SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 95 (FIXED & MOVEABLE WINDOW SYSTEMS)REPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTINSTALLATION PROCEDURE
2008 Pontiac Grand Prix Base

Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Buick LaCrosse and 2007 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .
  2. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
  3. Install the windshield wipers arms and blades. Refer to Wiper Arm Replacement .
  4. Install the windshield garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
  5. Install the rearview mirror. Refer to Rearview Mirror Replacement .
  6. Connect the rain senor connector, if equipped.
  7. Connect the diversity antenna, if equipped.
  8. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
  9. Close the hood.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.