Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Buick LaCrosse and 2007 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the PCM to the PCM electrical connectors (4).

    Tighten:  Tighten the connectors to 8 N.m (71 lb in).

  2. Install the PCM and the wiring harness to the air cleaner housing assembly (3).
  3. Fig 1: View Of Air Cleaner Housing, Bolts, PCM & Harness
    GM444496Courtesy of GENERAL MOTORS CORP.
  4. Install the air cleaner housing cover (1).
  5. Install the air cleaner housing cover screws (2).

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

  6. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
  7. Install the left front inner fender brace. Refer to Front Fender Upper Diagonal Brace Replacement in Body Front End.
  8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) in Engine Electrical.
  9. The new PCM must be programmed. Refer to Control Module References in Computer/Integrating Systems.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.