Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Buick LaCrosse and 2007 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Install the air cleaner housing by pushing the housing (1) into the 2 rubber grommets (2) in the engine compartment.
- Install the PCM and the harness into the air cleaner housing (3).
- Install the air cleaner housing cover assembly (1).
- Install the air cleaner housing screws (2).
Tighten: Tighten the screws to 3 N.m (27 lb in).
- Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
- Install the left inner fender brace. Refer to Front Fender Upper Diagonal Brace Replacement in Body Front End.
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.