SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 9 (EXTERIOR TRIM)REPAIR INSTRUCTIONSCARGO TIE DOWN LOOP BRACKET REPLACEMENTINSTALLATION PROCEDURE
2008 Pontiac Grand Prix Base

Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Floor Liner, Push-In Retainers, Bracket
    GM1427854Courtesy of GENERAL MOTORS CORP.
  1. Install the bracket (3) to the floor liner (1).
  2. Install the new push-in retainers (2).
    3. Fig 2: Cargo Tie Down Loops
    GM1412532Courtesy of GENERAL MOTORS CORP.
  3. Position the cargo box liner to the floor.
  4. Install the cargo tie down loops (2).
    5. NOTE: Refer to Fastener Notice .
  5. Install the bolts (1).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  6. Reposition the midgate weatherstrip to the front edge of the cargo floor liner.
  7. Close the midgate.
  8. Cycle the window to the closed position.
  9. Close the endgate.
  10. Latch and secure the spare tire carrier.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.