SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 58 (ENGINE COOLING)REPAIR INSTRUCTIONSFAN REPLACEMENTINSTALLATION PROCEDURE
2008 Pontiac Grand Prix Base

Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not use or attempt to repair a damaged cooling fan assembly. Replace damaged fans with new assemblies. An unbalanced cooling fan could fly apart causing personal injury and property damage.
    Fig 1: View Of Fan Clutch & Fan Blade
    GM367006Courtesy of GENERAL MOTORS CORP.
  1. Install the fan clutch to the fan blade.
    2. NOTE: Refer to Fastener Notice .
  2. Install the bolts to the fan clutch.

    Tighten:  Tighten the bolts to 23 N.m (17 lb ft).

    3. Fig 2: View Of Fan Assembly Removed
    GM367004Courtesy of GENERAL MOTORS CORP.
  3. Install the fan blade to the vehicle.
    4. Fig 3: Installing J 46406 To Fan Clutch
    GM1406734Courtesy of GENERAL MOTORS CORP.
  4. Install J 46406  to the fan clutch. See Special Tools .

    Tighten:  Tighten the nut to 59 N.m (44 lb ft).

  5. Install the fan shroud. Refer to Fan Shroud Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.