SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (INSTRUMENT PANEL AND CONSOLE TRIM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Pontiac Grand Prix Base

Fastener Tightening Specifications

2008 Pontiac Grand Prix BaseSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications

Application Specification
Metric English
Center Stack Trim Panel 2 N.m 18 lb in
Closeout Panels to Center Stack 2 N.m 18 lb in
Cluster Trim Panel Screws 2 N.m 18 lb in
Console Extension Trim Bezel Screws 2 N.m 18 lb in
Data Link Connectors (DLC) Screws 2 N.m 18 lb in
DIC and Power Outlet Bracket Screws 1.6 N.m 14 lb in
Driver Side Kick Panel Screws 2 N.m 18 lb in
Floor Console Bracket Bolts 9 N.m 80 lb in
Floor Console End Panel Screws 1.6 N.m 14 lb in
Floor Console Top Panel Screws 2 N.m 18 lb in
HVAC Control Module to Center Stack 2 N.m 18 lb in
Instrument Panel Assembly to Carrier Support Screws 9 N.m 80 lb in
Instrument Panel Carrier Side Bolts 50 N.m 37 lb ft
Instrument Panel Upper Trim Pad Retaining Screws 2 N.m 18 lb in
Knee Bolster Screws 2 N.m 18 lb in
Onstar Module to Center Stack 2 N.m 18 lb in
Passenger Side Air Bag (PSIR) Bolts 2 N.m 18 lb in
Radio to Center Stack 2 N.m 18 lb in
Shift Handle Mounting Screw 1.6 N.m 14 lb in
Substraight to Frame Bolts 9 N.m 80 lb in
Subwoofer to Base Units 2 N.m 18 lb in
Traction Control Module to Center Stack 2 N.m 18 lb in
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.