Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 434 (ENGINE CONTROL SYSTEM & FUEL SYSTEM - 5.3L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSMANIFOLD ABSOLUTE PRESSURE SENSOR REPLACEMENTINSTALLATION PROCEDURE
2008 Pontiac Grand Prix Base
Installation Procedure
2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the MAP sensor grommet with clean engine oil, if required.
- Install the MAP sensor grommet (715), if required.
- Install the MAP sensor (714).
- Connect the MAP sensor electrical connector (2).
- Install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.