SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 43 (FRONT SUSPENSION)REPAIR INSTRUCTIONSSTABILIZER SHAFT INSULATOR REPLACEMENTINSTALLATION PROCEDURE
2008 Pontiac Grand Prix Base

Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Shaft With Insulators
    GM793301Courtesy of GENERAL MOTORS CORP.
  1. Place the insulators on the stabilizer shaft with the slits facing toward the front of the vehicle.
    2. Fig 2: Insulators & Stabilizer Shaft
    GM793300Courtesy of GENERAL MOTORS CORP.
  2. Install the insulators to the stabilizer shaft.
  3. Install the stabilizer shaft.
  4. Install the clamps over the insulators and the stabilizer shaft.
    5. NOTE: Refer to Fastener Notice .
  5. Install insulator clamp bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  6. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  7. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.