Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 406 (FRAME AND UNDERBODY)REPAIR INSTRUCTIONSENGINE SPLASH SHIELD REPLACEMENTINSTALLATION PROCEDURE
2008 Pontiac Grand Prix Base
Installation Procedure
2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Install the engine splash shield to the lower flange of the engine compartment side rail.
- Route the ABS lead through the slot in the engine splash shield.
- Align the holes in the engine splash shield to holes in the outboard side engine compartment side rail.
- Insall the push-in retainers to the engine splash shield.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.