Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wiper Arm Blade
    GM815213Courtesy of GENERAL MOTORS CORP.
  1. Install the hook of the wiper arm through the opening in the wiper blade.
  2. Fig 2: Identifying Wiper Arm To Wiper Blade
    GM815214Courtesy of GENERAL MOTORS CORP.
  3. Position the wiper blade pivot in the inside radius of the wiper arm hook.
  4. Press the wiper blade pivot into the wiper arm hook until the pivot locks into the hook.
  5. Operate the windshield wipers and inspect for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.