Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Position the washer solvent container to the right frame rail.
- Install the lower washer solvent container screws.
Tighten: Tighten the screws to 10 N.m (89 lb in).
- Install the washer pump to the container.
- Install the level sensor to the container.
- Connect the washer solvent level sensor electrical connector.
- Connect the washer pump electrical connector.
- Connect the washer pump hose.
- Install the right front fender liner. Refer to Front Fender Liner Replacement .
- Install the upper washer solvent container screw.
Tighten: Tighten the screw to 10 N.m (89 lb in).
- Fill the washer solvent container with washer solvent.
- Close the hood.
NOTE:
Refer to Fastener Notice
.
Fig 2: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.