Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Testing
2008 Pontiac Grand Prix BaseSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the harness connector at the Tire Pressure Control Module.
- Disconnect the harness connector at the IPC.
- Test for less than 1 ohm of resistance between the vehicle speed signal circuit terminal 2 and terminal 17.
- If greater than the specified value, test the vehicle speed signal circuit for an open/high resistance.
- Test for infinite resistance between the vehicle speed signal circuit terminal 2 and ground.
- If not the specified value, test vehicle speed signal circuit for a short to ground, if circuit tests normal replace the tire pressure control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.