Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Install the windshield washer pumps (1) to the windshield washer solvent container (2).
- Install the windshield washer solvent container (2) by inserting the neck through the holes until tabs click.
- Install the 3 bolts to the windshield washer solvent container (2).
Tighten: Tighten the washer solvent container bolts to 5.5 N.m (49 lb in).
- Connect the washer hoses (4) to the washer pumps (3).
- Connect the washer pump electrical connectors (1).
- Install the right wheel house panel. Refer to Wheelhouse Panel Replacement .
- Install the right fender flare. Refer to Front Fender Flare Replacement .
- Fill the washer solvent container (2) with washer solvent.
NOTE:
Refer to FASTENER NOTICE
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.