Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Windshield Stoppers
    GM867289Courtesy of GENERAL MOTORS CORP.
  1. Replace the upper windshield stoppers (1) and (2).
  2. Install a stationary window into the opening. Refer to Adhesive Installation of Stationary Windows .
  3. Fig 2: Windshield Side Garnish Molding
    GM241992Courtesy of GENERAL MOTORS CORP.
  4. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
  5. Install the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
  6. Close the hood.
  7. Install the rearview mirror. Refer to Inside Rearview Mirror Replacement .
  8. Install the windshield side garnish moldings (1). Refer to Windshield Pillar Garnish Molding Replacement .
  9. Remove the double layer of masking tape from around the perimeter of the painted surfaces and the interior trim.
  10. Close the door.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.