Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the rod to the liftgate window latch.
- Install the liftgate window latch (1) to the liftgate (5).
- Install the bolts (2) to the liftgate window latch (1).
Tighten: Tighten the liftgate window latch bolts to 7.0 N.m (62 lb in).
- Install the rear liftgate window connector (4) to the liftgate (5).
- Install the bolts (3) to the liftgate window connector (4).
Tighten: Tighten the liftgate window connector bolts to 7.0 N.m (62 lb in).
- Close the liftgate window.
- Open the liftgate.
- Install the liftgate window latch electrical connector retainer (3) to the liftgate (4).
- Connect the liftgate window latch electrical connector (2) to the liftgate harness (1).
- Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
- Close the liftgate.
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.