Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2008 Pontiac Grand Prix BaseSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the SIR system. Refer to SIR Disabling and Enabling .
- Remove the front door sill plate. Refer to Door Sill Plate Replacement .
- Remove the rear door sill plate. Refer to Door Sill Plate Replacement .
- Remove the center pillar lower trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
- Remove the front seat belt retractor. Refer to Seat Belt Retractor Pretensioner Replacement - Left Front or Seat Belt Retractor Pretensioner Replacement - Right Front .
- Remove the side impact sensor electrical connector.
- Remove the side impact sensor fastener (2).
- Remove the side impact sensor (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.