Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
- Install the ignition lock cylinder by performing the following procedure:
- Align the positioning locking tab slot on the ignition lock cylinder case to the positioning tab on the ignition lock cylinder.
- Push the lock cylinder in until the tab locks in the ignition lock cylinder case.
- Enable the SIR system. Refer to SIR Disabling and Enabling .
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
- Perform the Passlock learn procedure. Refer to Programming Theft Deterrent System Components .
Fig 1: View of Ignition Cylinder Lock, Ignition Lock Cylinder Case Assembly and Upper Steering Column
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.