Fuse Block - Underhood Label

2008 Pontiac Grand Prix BaseSECTION Fuse Block - Underhood Label
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Fuse Block - Underhood Label
GM1499441Courtesy of GENERAL MOTORS CORP.
Fuse Block - Underhood Label Usage

Device Rating Description
STUD 1 Fuse 40A Trailer Wiring
MBEC Fuse 50A SEAT CB, RT DOOR CB
BLOWER Fuse 40A HVAC Blower Motor - High Speed
LBEC 2 Fuse 50A LOCKS Fuse, DDM Fuse, PDM Fuse, AUX PWR 2 Fuse
STUD 2 Fuse 30A Trailer Wiring, Off Road Lamps
ABS Fuse 60A Electronic Brake Control Module (EBCM)
VSES/ECAS Fuse 60A ECAS Relay
IGN A Fuse 40A Ignition Switch RUN, START, RUN/START/ACCY, STARTER Relay
IGN B Fuse 40A Ignition Switch RUN/ACC, RUN/START
LBEC 1 Fuse 50A FLASH Fuse, TBC 2A Fuse, TBC 2B Fuse, TBC 2C Fuse, LT DOORS Fuse
TRL PARK Fuse 15A Trailer Wiring
RR PARK Fuse 10A Tail/Stop Lamp - Right, License Lamp - Right, Side Marker Lamp - Right Rear
LR PARK Fuse 10A Tail/Stop Lamp - Left, License Lamp - Left, Side Marker Lamp - Left Rear
INT PARK RF Fuse 10A SIR Defeat Switch, Clearance Lamps, Marker Lamps, Trailer Jumper
STOP LP Fuse 25A Stop Lamp Switch
TBC BATT Fuse 10A BCM
PARK LP Relay - TRLR PARK Fuse, LR PARK Fuse, RR PARK Fuse, F PARK Fuse, MARKER LP Fuse
STARTER Relay - Starter
S/ROOF Fuse 25A Sunroof Module
SEO B2 Fuse 30A Electronic Brake Control Module (EBCM)
4WS Fuse 15A EVAP Canister Vent Solenoid
RR HVAC 30A Rear HVAC Module
AUX PWR Fuse 20A Accessory Power Outlets
PCM 1 Fuse 15A Evaporative Emission (EVAP) Canister Purge Solenoid, Powertrain Control Module (PCM), Mass Air Flow (MAF) Sensor/Intake Air Temperature (IAT) Sensor
ETC/ECM Fuse 15A Throttle Actuator Control (TAC), Electronic Brake Control Module (EBCM)
INJ 1 Fuse 15A Odd Ignition Coils, Odd Fuel Injectors
INJ 2 Fuse 15A Even Ignition Coils, Even Fuel Injectors
IGN E Fuse 10A A/C Compressor Relay, I/P Cluster, Turn/Hazard Switch
RTD Fuse 30A Not Used
TRL B/U Fuse 10A BCM Module, Trailer Connector
PCM B Fuse 20A Fuel Pump Relay, PCM
F/PMP Relay - Fuel Pump
O2 Sensor A Fuse 15A Heated Oxygen Sensors - Left/Right - Before Catalytic Converter
B/U LP Fuse 20A Park/Neutral Position Switch (PNP)
RR DEFOG Fuse 30A DEFOG Relay
HDLP-HI Relay - High Beam - Left, High Beam - Right
O2 B Fuse 15A Heated Oxygen Sensors - Left/Right - After Catalytic Converter
SIR Fuse 15A Inflatable Restraint I/P Module Disable Switch, Inflatable Restraint Sensing and Diagnostic Module (SDM)
FRT PARK Fuse 10A LF/RF Park/Turn Lamps, LF/RF Side Marker Lamps
SEO IGN Fuse 10A Rear Defogger Relay
TBC IGN 1 Fuse 10A Body Control Module (BCM)
HI HDLP - LT Fuse 10A Headlamp - High Beam - Left
LH HID Fuse 20A Not Used
DRL Relay - DRL - Left, DRL - Right
DRL Fuse 10A Daytime Running Lamps (DRL) Relay
IPC/DIC Fuse 10A Instrument Panel Cluster (IPC)
HVAC/ECAS Fuse 10A HVAC Control Module, Air Suspension Module
CIG LTR Fuse 15A Cigar Lighter, Data Link Connector (DLC)
HI HDLP RT Fuse 10A Highbeam Headlamp - Right
HDLP-LOW Relay - Headlamp - Low Beam - Left, Headlamp - Low Beam - Right
A/C COMP Relay - A/C Compressor Clutch Assembly
A/C COMP Fuse 10A A/C Compressor Clutch Relay
RR WPR 25A Rear Window Wiper Motor
RADIO Fuse 15A Radio, Rear Seat Audio (RSA)
SEO B1 Fuse 15A Heated Seat Module - LR/RR, Garage Door Opener
LO HDLP - LT Fuse 10A Headlamp - Low Beam - Left
BTSI Fuse 10A Stoplamp Switch, Floor Shifter Shift Lock Control Solenoid
CRANK Fuse 10A Ignition Switch, PCM Module
LO HDLP - RT Fuse 10A Headlamp - Low Beam - Right
FOG LP Relay - Not Used
FOG LP Fuse 15A Not Used
HORN Relay - Horn - Low Note, Horn - High Note
W/S WASH Relay - Front Windshield Washer Motor and Module
W/S WASH Fuse 15A W/S WASH Relay, Front Windshield Washer Motor and Module
INFO Fuse 15A Vehicle Communication Interface Module (VCIM)
RADIO AMP Fuse 30A Radio Amplifier
RH HID Fuse 20A Not Used
HORN Fuse 15A Horn - High/Low Note
EAP Fuse 15A Not Used
TREC Fuse 30A Transfer Case Control Module
SBA Fuse 15A Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.