Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 288 (POWER STEERING)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Pontiac Grand Prix Base
Fastener Tightening Specifications
2008 Pontiac Grand Prix BaseSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Pitman Arm Nut | 250 N.m | 184 lb ft |
| Power Steering Cooler Inlet/Outlet Hose Fitting | 28 N.m | 20 lb ft |
| Power Steering Cooler Mounting Bolt | 5 N.m | 44 lb in |
| Power Steering Flow Control Valve Fitting | 75 N.m | 55 lb ft |
| Power Steering Gear Inlet Hose Fitting | 28 N.m | 21 lb ft |
| Power Steering Pump Bolt | 50 N.m | 37 lb ft |
| Power Steering Pump Hose Nut | 28 N.m | 21 lb ft |
| Power Steering Pump Mounting Stud | 58 N.m | 44 lb ft |
| Power Steering Pump Rear Bracket Retaining Nut | 50 N.m | 37 lb ft |
| Steering Gear Bolt | 150 N.m | 110 lb ft |
| Steering Gear Pitman Shaft Housing Cover Bolt | 62 N.m | 46 lb ft |
| Steering Gear Pitman Shaft Lash Adjuster Nut | 49 N.m | 36 lb ft |
| Stub Shaft Housing Bolt | 62 N.m | 46 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.