SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 284 (DISC BRAKES)SPECIFICATIONSDISC BRAKE COMPONENT SPECIFICATIONS
2008 Pontiac Grand Prix Base

Disc Brake Component Specifications

2008 Pontiac Grand Prix BaseSECTION Disc Brake Component Specifications
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Front Brakes JH6
  • Rotor Discard Thickness
 36.50 mm 1.437 in
  • Rotor Minimum Allowable Thickness After Refinish
 37.0 mm 1.457 in
  • Rotor Thickness - New
 38.0 mm 1.496 in
  • Rotor Maximum Allowable Assembled Lateral Runout
 0.13 mm 0.005 in
  • Rotor Maximum Allowable Scoring
 1.50 mm 0.059 in
  • Rotor Maximum Allowable Thickness Variation
 0.025 mm 0.001 in
Rear Brakes JH6
  • Rotor Discard Thickness
 27.50 mm 1.083 in
  • Rotor Minimum Allowable Thickness After Refinish
 28.0 mm 1.102 in
  • Rotor Thickness - New
 29.0 mm 1.142 in
  • Rotor Maximum Allowable Assembled Lateral Runout
 0.13 mm 0.005 in
  • Rotor Maximum Allowable Scoring
 1.50 mm 0.059 in
  • Rotor Maximum Allowable Thickness Variation
 0.025 mm 0.001 in
*All brake rotors have a discard dimension cast into them. Replace any rotor that does not meet this specification. After refinishing the rotor, replace any rotor that does not meet the minimum thickness specifications.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.