SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 280 (SEAT HEATING AND COOLING)REPAIR INSTRUCTIONSREAR SEAT HEATER CONTROL MODULE REPLACEMENT
2008 Pontiac Grand Prix Base

Rear Seat Heater Control Module Replacement

2008 Pontiac Grand Prix BaseSECTION Rear Seat Heater Control Module Replacement
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Seat Heater Control Module
GM1964123Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Fold the rear seat forward.
  2. Remove the rear seat cushion latch covers by pulling upward to disengage the retainers.
1 Rear Seat Heater Control Module Nut (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  2 N.m (18 lb in)
2 Rear Seat Heater Control Module

Procedure

  1. Disconnect the electrical connectors.
  2. Refer to Control Module References for programming and set-up information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.