Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 273 (COMPONENT LOCATIONS & CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSTHROTTLE BODY
2008 Pontiac Grand Prix Base
Throttle Body
2008 Pontiac Grand Prix BaseSECTION Throttle Body
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Connector Part Information
|
Terminal Part Information
|
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| A | 0.5 BN | 582 | TAC Motor Control - 2 |
| B | 0.5 YE | 581 | TAC Motor Control - 1 |
| C | 0.5 TN | 2752 | Low Reference |
| D | 0.5 D-GN | 485 | TP Sensor 1 Signal |
| E | 0.5 GY | 2701 | 5-Volt Reference |
| F | 0.5 PU | 486 | TP Sensor 2 Signal |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.