Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 27 (MIRRORS)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2008 Pontiac Grand Prix Base
Scan Tool Data List
2008 Pontiac Grand Prix BaseSECTION Scan Tool Data List
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Driver Door Module/Passenger Door Module
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/Vehicle in PARK/All doors closed | |||
| Base Software P/N | Module Info. | Decimal | 16XXX |
| Base Software Suffix | Module Info. | ASCII | XX |
| Battery 1 (Low Current) | Data | Volts | 12.8 |
| Battery 2 (High Current) | Data | Volts | 12.8 |
| Calibration P/N | Module Info. | Decimal | 16XXX |
| Calibration Suffix | Module Info. | ASCII | 16XXX |
| Memory Switch | Inputs | Idle, Exit, Memory 1, Memory 2 | Idle |
| Mirror 5 Volt Reference | Outputs | On,Off | On |
| Mirror Heater | Outputs | Inactive, Active | Inactive |
| Mirror Horizontal Position | Data | Volts | Varies |
| Mirror Motor | Outputs | Idle, Left, Right, Up, Down | Idle |
| Mirror Select Switch | Inputs | Neutral, Left, Right | Neutral |
| Mirror Switch Horizontal | Inputs | Idle, Left, Right | Idle |
| Mirror Switch Vertical | Inputs | Idle, Up, Down | Idle |
| Mirror Vertical Position | Data | Volts | Varies |
| Program Software P/N | Module Info. | Decimal | 16XXX |
| Program Software Suffix | Module Info. | ASCII | XX |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.