SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 262 (VEHICLE ACCESS)REPAIR INSTRUCTIONSENDGATE HANDLE REPLACEMENTINSTALLATION PROCEDURE
2008 Pontiac Grand Prix Base

Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Endgate Handle
    GM1412522Courtesy of GENERAL MOTORS CORP.
  1. Position the handle to the endgate.
  2. Loosely install the fasteners.
    3. Fig 2: Lock Rod Retaining Clips
    GM1428164Courtesy of GENERAL MOTORS CORP.
  3. Connect the lock rods (1, 3) to the handle assembly (2).
    4. NOTE: Refer to Fastener Notice .
  4. Connect the lock rod clips (4, 5).

    Tighten:  Tighten the endgate handle bolts to 25 N.m (18 lb ft).

    5. Fig 3: Endgate Trim Bezel
    GM1412524Courtesy of GENERAL MOTORS CORP.
  5. Secure the trim panel bezel to the endgate. Lift the handle slightly to assist in bezel installation.
  6. Secure the bezel clips.
  7. Close the endgate.
  8. Latch and secure the spare tire carrier.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.