Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 262 (VEHICLE ACCESS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B3130CIRCUIT/SYSTEM TESTING
2008 Pontiac Grand Prix Base
Circuit/System Testing
2008 Pontiac Grand Prix BaseSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the IP fuse block and connect a test lamp from the door unlock relay control circuit terminal A3 in connector X3 to ground.
- Ignition ON, verify that the test lamp does not illuminate.
- If the test lamp illuminates test the control circuit for a short to voltage. If the circuit tests normal replace the BCM.
- If the circuits test normal replace the IP fuse block.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.