SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 260 (HEATING, VENTILATION, AND AIR CONDITIONING)REPAIR INSTRUCTIONSBLOWER MOTOR CONTROL MODULE REPLACEMENT
2008 Pontiac Grand Prix Base

Blower Motor Control Module Replacement

2008 Pontiac Grand Prix BaseSECTION Blower Motor Control Module Replacement
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Blower Motor Control Module Replacement
GM1696338Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the I/P insulator panel. Refer to Instrument Panel Insulator Panel Replacement .
  2. Disconnect the blower motor control module electrical connector.
1 Blower Motor Control Module Screw (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  1.5 N.m (13 lb in)
2 Blower Motor Control Module
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.