Circuit/System Testing

2008 Pontiac Grand Prix BaseSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify there are no obstructions that may block the infra-red port located at the lower edge of the video display screen.
    • If an obstruction exists, remove the obstruction.
  2. Operate the DVD player in play mode. Press multiple buttons on the remote control in succession and verify the remote is inoperative on every button pressed.
  3. Test the remote's functionality with the other screen.
    • If the remote is inoperative, replace the remote batteries.
    • If remote batteries are OK and remote remains inoperative, replace the remote control.
  4. Replace the suspect display screen containing the infra-red port if the remote and batteries are OK.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.