Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Align the tab on the midgate window sealing strip to the notch in the midgate flange.
- Install the window sealing strip to the midgate flanges, pressing down until the seal is fully seated.
- Install the sealing strip screws.
Tighten: Tighten the screws to 0.675 N.m (6 lb in).
- Remove the pins (2) or allen wrenches from the midgate hinges (1) supporting the midgate.
- Close the midgate, ensuring the latches are fully engaged.
- Install the center lower interior trim. Refer to Endgate Center Molding Replacement (SUT) .
- Close the midgate window. Ensure the window sealing strip remains fully seated and not binding against the midgate window.
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.