SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 252 (FIXED AND MOVEABLE WINDOWS)DIAGNOSTIC INFORMATION AND PROCEDURESPOWER WINDOWS MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2008 Pontiac Grand Prix Base

Circuit/System Verification

2008 Pontiac Grand Prix BaseSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the operation of the power windows while commanding each window UP and DOWN by using their respective window switches, each window should perform the UP and DOWN function.
    • If the driver window is inoperative, refer to Circuit/System Testing  for Driver Window Malfunction.
    • If the front passenger window is inoperative, refer to Circuit/System Testing  for Passenger Window Malfunction.
    • If either rear passenger power window is inoperative, refer to Circuit/System Testing  for Rear Passenger Window Malfunction.
  2. Observe the scan tool Driver Window RF Switch, Driver Window LR Switch and Driver Window RR Switch parameters while using the driver master control switches. The reading should change between OFF/UP/DOWN/EXPRESS DOWN.
    • If the parameter does not change, replace the DDS.
  3. Observe the scan tool Window Lockout Switch parameter while pressing and depressing the window lockout switch on the driver master control. The reading should change between ON and OFF.
    • If the parameter does not change, replace the DDS.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.