Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Testing
2008 Pontiac Grand Prix BaseSECTION Component Testing
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Midgate Window Switch
- Ignition OFF, disconnect the harness connector at the midgate window switch.
- Test for infinite resistance between the signal terminals B and C and the ignition terminal A with the switch in the INACTIVE position.
- If less than the specified value, replace the midgate window switch.
- Test for less than 2-ohms between the signal terminal C and the ignition terminal A with the switch in the UP position.
- If greater than the specified range, replace the midgate window switch.
- Test for less than 2-ohms between the signal terminal B and the ignition terminal A with the switch in the DOWN position.
- If greater than the specified range, replace the midgate window switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.