SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 251 (INSTRUMENT PANEL AND CONSOLE TRIM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Pontiac Grand Prix Base

Fastener Tightening Specifications

2008 Pontiac Grand Prix BaseSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Air Distributor Duct Outer Screw 2.5 N.m 22 lb in
Air Distributor Duct Upper Screw 2.5 N.m 22 lb in
ALDL Screw 2.5 N.m 22 lb in
Console Shift Lever Bezel Screw 2.5 N.m 22 lb in
Front Floor Console Armrest Screw 2.5 N.m 22 lb in
Front Floor Console Compartment Bezel Screw 2.5 N.m 22 lb in
Front Floor Console Screw/Bolts 2.5 N.m 22 lb in
Instrument Panel Carrier Nut 9 N.m 80 lb in
Instrument Panel Carrier Screw 2.5 N.m 22 lb in
Instrument Panel Carrier Support Lower Bolt 22 N.m 16 lb ft
Instrument Panel Carrier Support Outer Bolt 58 N.m 43 lb ft
Instrument Panel Carrier Support Upper Bolt 22 N.m 16 lb ft
Instrument Panel Carrier Upper Bolts 9 N.m 80 lb in
Instrument Panel Cluster Trim Plate Bezel Screw 2.5 N.m 22 lb in
Instrument Panel Compartment Door Latch Screw 2.5 N.m 22 lb in
Instrument Panel Compartment Door Opening Frame Screw 2.5 N.m 22 lb in
Instrument Panel Compartment Door Screw 2.5 N.m 22 lb in
Instrument Panel Drivers Knee Bolster Deflector Nuts 9 N.m 80 lb in
Instrument Panel Drivers Knee Bolster Screws 2.5 N.m 22 lb in
Instrument Panel Insulator Panel Screw 2.5 N.m 22 lb in
Overhead Console Screw 10 N.m 89 lb in
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.