SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 247 (WIPERS AND WASHERS)REPAIR INSTRUCTIONSREAR WINDOW WIPER CONTROL MODULE REPLACEMENT
2008 Pontiac Grand Prix Base

Rear Window Wiper Control Module Replacement

2008 Pontiac Grand Prix BaseSECTION Rear Window Wiper Control Module Replacement
WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Window Wiper Control Module Replacement
GM1736959Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
Preliminary Procedure: 
Remove the rear liftgate trim panel. Refer to Liftgate Trim Panel Replacement (SUV) .
1 Wiper Motor Electrical Connector
2 Main Liftgate Harness Electrical Connector
3 Rear Window Wiper Control Module
Tip: 
  • Using a flat-bladed tool, insert the tool behind the control module and release the locking tab in order to slide and remove the wiper control module from the wiper motor bracket.
  • Program the rear window wiper control module. Refer to Control Module References .
4 Rear Window Wiper Motor Bracket
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.