Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
- Crank Request Signal
-
The scan tool displays Yes/No. The scan tool displays Yes when the powertrain control module (PCM) receives a crank request.
- Ignition 1 Signal
-
The scan tool displays voltage. The scan tool displays the current voltage at the battery.
- GEN L-Terminal Signal Command
-
The scan tool displays On/Off. The scan tool displays Off until the engine is started, then it will display On.
- GEN F-Terminal Signal
-
The scan tool displays 0%-100%. The scan tool displays 0%-5% until the engine is running, then the percentage value varies depending on electrical loads.
- TR Sw.
-
The scan tool displays Park, Reverse, Neutral, Drive 4, Drive 3, Drive 2 and Drive 1. The scan tool displays the position of the transmission range switch.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.