Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake pedal and bushings.
- Install the brake pedal nut and bolt.
Tighten: Tighten the brake pedal nut and bolt to 40 N.m (30 lb ft).
- Install the brake pedal washer and pushrod to the brake pedal.
- Install the brake pedal pushrod retaining clip to the brake pedal.
- Secure the wiring harness clips to the bracket.
- Connect the brake pedal position sensor electrical connector.
- Insert the top of the BCM up into the mounting bracket, then engage the bottom of the BCM into the mounting bracket slot.
- Install the left instrument panel insulator.
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.