Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Lower Control Arm Bushing Replacement (Vertical): Notes
2008 Pontiac Grand Prix BaseSECTION Notes
WARNING: This page is about a different car, the 2007 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required
- J 21474-01
Control Arm Bushing Set. See Special Tools .
- J 21474-27 1/2 Inch Puller Bolt Thrust Bearing
- J 21474-2 Bushing Installer Remover. See Special Tools .
- J 21474-4 Nut
- J 21474-13 Control Arm Bushing Installer. See Special Tools .
- J 23444-A High Pressure Lubricant. See Special Tools .
- J 34126 Driven Sprocket Support Bearing Installer. See Special Tools .
- J 35379 Front Knuckle Support. See Special Tools .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.