SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 173 (FRAME & UNDERBODY)REPAIR INSTRUCTIONSFRONT FENDER LINER REPLACEMENTINSTALLATION PROCEDURE
2008 Pontiac Grand Prix Base

Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Fender Liner
    GM1229766Courtesy of GENERAL MOTORS CORP.
  1. Position the front fender liner to the front fender.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the front fender liner screws to the wheel opening.

    Tighten:  Tighten the front fender liner screws to 7 N.m (61 lb in).

  3. Install the front fender liner screws to the lower rear of the fender.

    Tighten:  Tighten the screws to 7 N.m (61 lb in).

  4. Install the front fender liner screws to the lower engine compartment side rail.

    Tighten:  Tighten the screws to 7 N.m (61 lb in).

  5. Install the front fender liner screws at the front bumper fascia.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  6. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.