Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sunroof Window Panel Screws
    GM294278Courtesy of GENERAL MOTORS CORP.
  1. Position the sunroof window panel to the sunroof module.

    Ensure that the information logo stencil is towards the rear of the sunroof opening.

  2. NOTE: Refer to Fastener Notice .
  3. Install the sunroof window panel screws to the sunroof window panel.

    Tighten:  Tighten the sunroof window panel screws to 4 N.m (35 lb in).

  4. Adjust the sunroof window panel as necessary. Refer to Sunroof Window Height and Opening Fit Adjustment .
  5. Inspect the sunroof window panel for proper operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.