Seat Switch Replacement - Power

2008 Pontiac Grand Prix BaseSECTION Seat Switch Replacement - Power
WARNING: This page is about a different car, the 2007 Buick LaCrosse and 2007 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Seat Switch
GM1541231Courtesy of GENERAL MOTORS CORP.
Seat Switch Replacement - Power

Callout Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
1 Knob, Power Seat Adjuster Switch
2 Retainer Clip, Seat Recliner Handle
3 Handle, Seat Recliner
4 Screw, Seat Adjuster Finish Cover (Qty: 3)

Tighten:  2 N.m (18 lb in)

5 Cover, Seat Adjuster Finish
6 Switch, Power Seat Adjuster
Tip: 
  1. Disconnect the electrical connector.
  2. Unclip the switch from the seat outer adjuster cover.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.