Power Seat Component Views

2008 Pontiac Grand Prix BaseSECTION Power Seat Component Views
WARNING: This page is about a different car, the 2007 Buick LaCrosse and 2007 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front of Instrument Panel
GM1509879Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Lamp Switch Assembly - Fog Lamp
2 Instrument Panel Cluster (IPC)
3 Ignition Switch
4 Air Temperature Sensor - Inside
5 Sunload Sensor Assembly (CJ2) or Ambient Light Sensor (C67)
6 Theft LED
7 Driver Information Center (DIC)
8 Radio
9 HVAC Control Module
10 Heated Seat Switch - Front Passenger
11 Cigar Lighter
12 Heated Seat Switch - Driver
13 Steering Wheel Controls - Right
14 Cruise Control Switch
15 Voice Recorder / Cruise Switch Assembly
16 Steering Wheel Controls - Left
17 Turn Signal / Multifunction Switch
18 I/P Dimmer Switch
19 Lamp Switch Assembly - Interior Lamps
Fig 2: Driver Seat
GM1507667Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Seat Frame
2 Seat Lumbar Motor - Driver (AL9)
3 Heated Seat Element - Driver Back
4 Heated Seat Element - Driver Cushion
5 Seat Lumbar Switch - Driver (AL9)
6 Seat Adjuster Switch - Driver
7 Heated Seat Relay
8 Horizontal Motor (part of the Adjuster Assembly)
9 Front Vertical Motor (part of the Adjuster Assembly)
10 Rear Vertical Motor (part of the Adjuster Assembly)
11 Seat Belt Pretensioner - Left
Fig 3: Passenger Seat
GM1507669Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Heated Seat Element - Passenger Cushion
2 Heated Seat Element - Passenger Back
3 Passenger Presence Seat Sensor
4 Heated Seat Relay
5 Horizontal Motor (part of the Adjuster Assembly)
6 Front Vertical Motor (part of the Adjuster Assembly)
7 Rear Vertical Motor (part of the Adjuster Assembly)
8 Inflatable Restraint Front Passenger Presence System (PPS) Module
9 Seat Adjuster Switch - Passenger
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.