Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (STEERING WHEEL AND COLUMN)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2008 Pontiac Grand Prix Base
Fastener Tightening Specifications
2008 Pontiac Grand Prix BaseSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Horn Contact Plate Screws | 5.5 N.m | 49 lb in |
| Ignition Lock Cylinder Case Screws | 7 N.m | 62 lb in |
| Intermediate Shaft to the Steering Column Pinch Bolt | 62 N.m | 46 lb ft |
| Intermediate Shaft to the Steering Gear Pinch Bolt | 47 N.m | 35 lb ft |
| Steering Column Electrical Connector Screw | 6 N.m | 53 lb in |
| Steering Column Mounting Nuts | 27 N.m | 20 lb ft |
| Steering Column Trim Cover Screws Upper | 1 N.m | 9 lb in |
| Steering Wheel Nut | 41 N.m | 30 lb ft |
| Steering Wheel Shroud Retaining Screws | 2 N.m | 18 lb in |
| Transfer Case Electronic Control Module Bracket | 2 N.m | 18 lb in |
| Turn Signal Multifunction Switch Screws Side | 7 N.m | 62 lb in |
| Turn Signal Multifunction Switch Screws Top | 3 N.m | 27 lb in |
| Upper Intermediate Shaft to Lower Intermediate Shaft Pinch Bolt | 50 N.m | 37 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.