Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 133 (TIRE PRESSURE MONITORING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL OUTPUT CONTROLS
2008 Pontiac Grand Prix Base
Scan Tool Output Controls
2008 Pontiac Grand Prix BaseSECTION Scan Tool Output Controls
WARNING: This page is about a different car, the 2007 Buick LaCrosse and 2007 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Output Controls
| Scan Tool Output Control | Additional Menu Selections | Description |
|---|---|---|
| TPM Option Enable | Module Setup/New RCDLR | After replacing the Remote Control Door Lock Receiver (RCDLR) assembly, the SPS reprogramming must be used to enable the TPM option, refer to Remote Control Door Lock Receiver Programming and Setup . |
| Tire Type/Pressure Selection | Module Setup | After replacing the RCDLR assembly, the scan tool must be used to select the correct tire type and the front and rear tire pressures for the vehicle being serviced. Refer to Remote Control Door Lock Receiver Programming and Setup . |
| TPM Learn Mode | Module Setup | The sensor learn procedure must be performed after every tire rotation, RCDLR replacement, or sensor replacement. Once the TPM learn mode has been enabled, each of the sensors unique identification (ID) codes can be learned in to the RCDLR's memory. Refer to Tire Pressure Sensor Learn . |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.