Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1 (CAUTIONS AND NOTICES)
2008 Pontiac Grand Prix Base
Section 1 (Cautions And Notices)
2008 Pontiac Grand Prix BaseSECTION Section 1 (Cautions And Notices)
WARNING: This page is about a different car, the 2006 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Introduction
- Definition of Caution, Notice, and Important
- ABS Component Handling Caution
- Approved Equipment for Collision Repair Caution
- Assistant Driving Caution
- Batteries Produce Explosive Gases Caution
- Battery Disconnect Caution
- Brake Dust Caution
- Brake Fluid Irritant Caution
- Brake Pipe Replacement Caution
- Breathing R-134a Caution
- Clutch Dust Caution
- Door Outer Panel Replacement Caution
- Eye Protection Caution
- Foam Sound Deadeners Caution
- Fuel and Evaporative Emission Pipe Caution
- Fuel Gage Leak Caution
- Fuel Pipe Fitting Caution
- Fuel Rail Stop Bracket Installation Caution
- Fuel Storage Caution
- Fuel Vapors in Evaporative Emission Components Caution
- Gasoline/Gasoline Vapors Caution
- Glass and Sheet Metal Handling Caution
- Halogen Bulb Caution
- Hood Hold-Open Device Caution
- Lower O-Ring Removal Caution
- Moving Parts and Hot Surfaces Caution
- Relieving Fuel Pressure Caution
- Replacement Carpet Caution
- Road Test Caution
- Safety Glasses Caution
- Safety Glasses and Compressed Air Caution
- Safety Goggles and Fuel Caution
- Servicing the SIR System Caution
- SIR Caution
- SIR Deployed Inflator Modules Are Hot Caution
- SIR Inflatable Module Deployment Outside Vehicle Caution
- SIR Inflator Module Coil Caution
- SIR Inflator Module Disposal Caution
- SIR Inflator Module Handling and Storage Caution
- SIR Special Tool Caution
- Valve Springs Can Be Tightly Compressed Caution
- Vehicle Lifting Caution
- Window Retention Caution
- Work Stall Test Caution
- Anti-Corrosion Materials Notice
- Belt Dressing Notice
- Brake Caliper Notice
- Brake Caliper Supporting to Prevent Hose Damage Notice
- Brake Fluid Effects on Paint and Electrical Components Notice
- Clearcoat/Ultraviolet Screeners Notice
- Component Fastener Tightening Notice
- Disengaging Connectors Notice
- Emission Modification Notice
- Engine Emission Notice
- Engine Lifting Notice
- Engine Mounting Notice
- Excessive Force and Oxygen Sensor Notice
- Fastener Notice
- Fuel Injector Balance Test Notice
- Fuel Pressure Notice
- Fuel Tank Strap Fastener Notice
- Handling Electrostatic Discharge Sensitive Parts Notice
- Handling Idle Air Control Valve Notice
- Heated Oxygen and Oxygen Sensor Notice
- Ignition OFF When Disconnecting Battery Notice
- Installing Hoses without Twists or Bends Notice
- Latched DTC B1018, B1024 Notice (SDM-RSD)
- Liftgate Assist Rod Notice
- Machined Surface Damage Notice
- Nylon Fuel Lines Notice
- OBDII Symbol Description Notice
- Powertrain Control Module and Electrostatic Discharge Notice
- Power Steering Hose Disconnected Notice
- Sealant Notice
- Service Programming System (SPS) Notice
- Servicing the Level Sensor Notice
- Silicon Contamination of Heated Oxygen Sensors Notice
- Single Cylinder Flooding Notice
- Stabilizer Shaft Link Damage Notice
- Steering Wheel in the Full Turn Position Notice
- Test Lamp to Ignition Control Module Circuit Connector Notice
- Test Probe Notice
- Transfer Case Seal Removal Notice
- Window Edge Damage Notice
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.