SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSVEHICLE LOCATION ANTENNA MODULE BRACKET REPLACEMENTINSTALLATION PROCEDURE
2008 Pontiac Grand Prix Base

Installation Procedure

2008 Pontiac Grand Prix BaseSECTION Installation Procedure
    Fig 1: View Of Antenna Module Bracket
    GM1202535Courtesy of GENERAL MOTORS CORP.
  1. Align the communication interface module to the vehicle location antenna module bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the communication interface module screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    3. Fig 2: View Of Vehicle Location Antenna Module Bracket Bolts
    GM1204600Courtesy of GENERAL MOTORS CORP.
  3. Align the vehicle location antenna module bracket to the locator on the I/P carrier (cross car beam).
  4. Start the bolts by hand to avoid cross threading. Install the vehicle location antenna module bracket bolts (3, 4, 5).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  5. Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.