Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2008 Pontiac Grand Prix BaseSECTION Installation Procedure
- Inspect the receiver bracket for foam tape. If the bracket is not equipped, install foam tape as shown (1, 2) to prevent rattles.
- Connect the antenna connector.
- Connect the electrical connector.
- Install the electrical connector CPA.
- Install the digital radio receiver to the receiver bracket.
- Install the digital radio receiver nuts.
Tighten: Tighten the nuts to 5 N.m (44 lb in).
- Align the receiver and bracket assembly to the studs.
- Install the receiver bracket nuts.
Tighten: Tighten the nuts to 4 N.m (35 lb in).
- Install the left rear compartment trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side .
- Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.