Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC2008GRAND PRIX BASEREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESAUDIO SYSTEM TROUBLESHOOTING HINTSGENERATOR WHINE CONCERNS
2008 Pontiac Grand Prix Base
Generator Whine Concerns
2008 Pontiac Grand Prix BaseSECTION Generator Whine Concerns
- Inspect the ground terminal and cable for high resistance.
- Inspect the generator and brackets for loose or coated mounting bolts.
- Inspect that the ground straps between the engine and the frame are clean and tight.
- If the noise is still present, inspect the charging system for proper operation.
- Install a filter GM P/N 1224205 in the battery voltage feed circuit to the radio.
- If the noise is not eliminated, install the filter in each following variation:
- Install the filter with the single wire side toward the radio and the ground wire attached to chassis ground.
- Remove the ground to the filter.
- Reverse the filter so the 2-wire side is toward the radio with the ground wire attached to chassis ground.
- Remove the ground from the filter.
- If the filter GM P/N 1224205 causes a delay when turning the radio ON or OFF, or other problems, remove the filter and install a 0.47 micro farad capacitor to chassis ground.
- Before reassembling the vehicle, remove any unneeded filters.
- Test the functionality all of the vehicle systems (including those not related to the audio system) for proper operation and function.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.