Fastener Tightening Specifications

1998 Pontiac Firebird V8-5.7L VIN GSECTION Fastener Tightening Specifications
Fastener Tightening Specifications
Accelerator and Cruise Control Servo Cable Adjuster Bolt 7Z Nm (66 inch lbs.)
Air Cleaner Bolt 12 Nm (106 inch lbs.)
Air Conditioning Condenser Tube Bolt 16 Nm (12 ft. lbs.)
Air Conditioning Condenser Tube Nut 16 Nm (12 ft. lbs.)
Coolant Heater Bolt (3.8L) 1.9 Nm (17 inch lbs.)
Coolant Heater (5.7L) 40 Nm (30 ft. lbs.)
Coolant Pump Bolt (5.7L) 25 Nm (18 ft. lbs.)
Coolant Pump Pulley Bolt (5.7L)-First Pass 10 Nm (89 inch lbs.)
Coolant Pump Pulley Bolt (5.7L)-Last Pass 25 Nm (18 ft. lbs.)
Coolant Recovery Reservoir Bolt 12 Nm (106 inch lbs.)
Cooling Fan Motor Bolts 6 Nm (53 inch lbs.)
Drive Belt Tensioner Bolt 50 Nm (37 ft. lbs.)
EGR Valve Outlet Pipe Bolt 29 Nm (21 ft. lbs.)
EGR Valve Outlet Pipe Nut 29 Nm (21 ft. lbs.)
Engine Coolant Temperature Sensor (3.8L) 25 Nm (18 ft. lbs.)
Engine Coolant Temperature Sensor (5.7L) 29 Nm (21 ft. lbs.)
Engine Block Coolant Drain Hole Plug (5.7L) 60 Nm (44 ft. lbs.)
Knock Sensor (3.8L) 19 Nm (14 ft. lbs.)
Air Lower Deflector Screw 10 Nm (89 inch lbs.)
Radiator Drain Cock 1.5 Nm (13 inch lbs.)
Transmission Oil Cooler Pipe Fittings at Radiator 27 Nm (20 ft. lbs.)
Water Outlet Bolt (3.8L) 27 Nm (20 ft. lbs.)
Water Outlet Bolt (5.7L) 15 Nm (11 ft. lbs.)
Water Pump Bolt (3.8L) 15 Nm (11 + 80° ft. lbs.)
Water Pump Pulley Bolt (3.8L) 13 Nm (115 inch lbs.)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.