Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPONTIAC1998FIREBIRD V8-5.7L VIN GREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSENGINE OIL LEVEL SENSOR/SWITCH DIAGNOSIS
1998 Pontiac Firebird V8-5.7L VIN G
Engine Oil Level Sensor/Switch Diagnosis
1998 Pontiac Firebird V8-5.7L VIN GSECTION Engine Oil Level Sensor/Switch Diagnosis
1 Of 2:
2 Of 2:
Circuit Description
The Oil Level switch is a normally open switch. When the oil level is within an acceptable range the Oil Level switch closes. The switch opens when the engine oil level drops below a predetermined amount. The PCM tests the Engine Oil Level switch circuit with the ignition ON (engine OFF). The PCM monitors the engine coolant temperature to ensure proper engine oil drain back to the oil pan. When the engine is colder the engine oil drain back process takes a greater amount of time.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
6. This step tests the Oil Level sensor signal circuit between the PCM and the sensor.
7. This step tests the Oil Level sensor ground circuit between the PCM and the sensor.
8. This step tests for an open in the Oil Level sensor signal circuit between the PCM and the Oil Level sensor.
9. This step tests the Oil Level signal circuit for a short to ground.
18. This step Clears the Low Oil Level message. The engine coolant temperature should decrease by 10°C (18°F).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.