Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994ACCLAIM V6-181 3.0L SOHCREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWERTRAIN MANAGEMENTRELAYS AND MODULES - COMPUTERS AND CONTROL SYSTEMSENGINE CONTROL MODULEDESCRIPTION AND OPERATIONMODES OF OPERATIONCLOSED LOOPCRUISE
1994 Plymouth Acclaim V6-181 3.0L SOHC
Cruise
1994 Plymouth Acclaim V6-181 3.0L SOHCSECTION Cruise
PCM MONITORS:
- Engine Temperature (ECT Sensor)
- Manifold Vacuum (MAP Sensor)
- Engine rpm (distributor pick-up)
- Throttle Position (TPS)
- Exhaust Gas Oxygen Content (O2S)
- A/C Switch Status
- Battery Voltage
PCM CONTROLS:
- Air/fuel ratio, by varying injector pulse width. Switches injector ground on and off twice per engine revolution.
- Idle speed, through the IAC motor.
- Ignition timing.
- Monitor oxygen sensor and fine tune air/fuel ratio by varying injector pulse width
- Operate A/C Compressor Clutch relay (if selected)
- Engine Temperature (ECT Sensor)
- Manifold Vacuum (MAP Sensor)
- Engine rpm (distributor pick-up)
- Throttle Position (TPS)
- Exhaust Gas Oxygen Content (O2S)
- A/C Switch Status
- Battery Voltage
PCM CONTROLS:
- Air/fuel ratio, by varying injector pulse width. Switches injector ground on and off twice per engine revolution.
- Idle speed, through the IAC motor.
- Ignition timing.
- Monitor oxygen sensor and fine tune air/fuel ratio by varying injector pulse width
- Operate A/C Compressor Clutch relay (if selected)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.