Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1994ACCLAIM V6-181 3.0L SOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSRELAYS AND MODULES - TRANSMISSION AND DRIVETRAINRELAYS AND MODULES - A/TCONTROL MODULESERVICE AND REPAIRREPLACEMENT
1994 Plymouth Acclaim V6-181 3.0L SOHC
Replacement
1994 Plymouth Acclaim V6-181 3.0L SOHCSECTION Replacement
NOTE: For JA/JX with 2.4L engine, remove air cleaner clamps and air cleaner.
REMOVAL
1. Disconnect the battery negative cable.
2. Loosen 60 way retaining screw, located in the center of the 60 way connector. Then disconnect the 60 way connector on Transmission Control Module.
3. Remove Transmission Control Module mounting screws and lift module from vehicle.
INSTALLATION
To install, reverse removal procedures.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.