General Information

1994 Plymouth Acclaim V6-181 3.0L SOHCSECTION General Information


Do not interchange Transmission Control Modules with previous-year transmission control modules. If a same year TCM is being used from a different vehicle, the following procedures must be performed:
- Quick Learn Procedure
- Electronic Pinion Procedure

The Transmission Control Module is located on the right fender inner panel, in the engine compartment. It is held in place by four mounting screws.

NOTE: If the Transmission Control Module has been replaced, the following procedures must be performed:
- Quick Learn Procedure: This procedure will allow the transmission control module to learn the characteristics of the vehicle.
- Electronic Pinion Factor Procedure: This procedure will reprogram the TCM to compensate for different tire sizes and final drive ratios.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.